LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (HVAC - Climate Control System -- F250-F550 Super Duty) >> Removal And Installation >> Footwell Duct - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seats. For additional information, refer to SEATING .
  2. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  3. Remove the RH and LH lower cowl trim panels and front door sill plates.
  4. NOTE: Position the carpet to allow access to the 2 rear footwell duct pin-type retainers.
  5. Remove the 2 rear footwell duct pin-type retainers.
  6. Remove the rear footwell duct.
  7. Remove the rear footwell duct extension.
  8. To install, reverse the removal procedure.