LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (HVAC - Climate Control System -- F250-F550 Super Duty) >> Removal And Installation >> Clutch and Clutch Field Coil >> Installation

Clutch and Clutch Field Coil: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: A new A/C compressor may come equipped with a clutch and pulley. If not, the A/C clutch components should be reused unless obvious signs of damage are found. If excessive grooving is found, a new A/C clutch disc and hub and a new A/C compressor pulley must be installed together. Otherwise, each component can be installed individually where needed.
  1. Visually inspect the A/C clutch disc and hub, A/C compressor pulley and A/C clutch field coil for damage.
    • Inspect for physical damage, including cracked or melted components or discoloration due to excessive heat.
    • Inspect for excessive wear, including grooving in the A/C clutch disc and hub or A/C compressor pulley that is more than fingernail depth.
    • Inspect for roughness in the A/C compressor pulley bearing.
  2. Clean the A/C clutch field coil and pulley mounting surfaces.
  3. Install the A/C clutch field coil.
  4. Install the A/C clutch field coil snap ring.
  5. Install the A/C clutch field coil electrical connector bracket screw.
    6. NOTE: The A/C compressor pulley is a tight fit on the A/C compressor. It must be correctly aligned during installation.
  6. Install the A/C compressor pulley.
  7. Install the A/C compressor pulley snap ring with the bevel side out.
  8. Place one nominal thickness A/C clutch disc and hub spacer inside the clutch hub spline opening.
  9. Install the A/C clutch disc and hub.
  10. Using the Compressor Clutch Holding Tool, install the A/C compressor clutch disc and hub bolt.
    1. Hold the A/C clutch disc and hub with the Compressor Clutch Holding Tool.
    2. Tighten the bolt to 14 Nm (124 lb-in).
      Fig 1: Installing A/C Clutch Disc And Hub Bolt
      G06064733Courtesy of FORD MOTOR CO.
  11. Measure and adjust the clutch air gap by removing or adding A/C clutch disc and hub spacers.
    Fig 2: Measuring Clutch Air Gap
    G06075362Courtesy of FORD MOTOR CO.
  12. Install the A/C compressor. For additional information, refer to AIR CONDITIONING (A/C) COMPRESSOR - 6.2L AND 6.8L  or AIR CONDITIONING (A/C) COMPRESSOR - 6.7L DIESEL .
scientia non olet · About LEMON Manuals