Temperature Blend Door Position

The dual-zone EATC system uses 2 temperature blend door actuators to control 2 separate temperature blend doors. The temperature blend doors independently vary the LH side and RH side temperature settings, as desired. The temperature blend door actuators each contain a reversible electric motor and a potentiometer. The potentiometer circuit consists of a 5-volt reference signal connected to one end of a variable resistor, and a signal ground connected to the other. A signal circuit is connected to a contact wiper, which is driven along the variable resistor by the actuator shaft. The signal to the HVAC module from the contact wiper indicates the position of the temperature blend door. The HVAC module powers the actuator motors to move the temperature blend doors to the desired positions. The desired temperature blend door positions are calculated by the HVAC module based on the set temperature, in-vehicle temperature, ambient temperature and sunload.

The LH temperature blend door actuator is located on the bottom of the heater core and evaporator core housing. The RH temperature blend door actuator is located on the top of the heater core and evaporator core housing.