Section 84 (Engine Emission Control System -- F250-F550 Super Duty): Specifications

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

MATERIAL SPECIFICATIONS

Item	Specification	Fill Capacity
High Temperature Nickel Anti-Seize Lubricant XL-2	-	-
Motorcraft® Orange Antifreeze/Coolant Concentrated VC-3-B (US); CVC-3-B2 (Canada)	WSS-M97B44-D	-
Penetrating and Lock Lubricant (US); Penetrating Fluid (Canada) XL-1 (US); CXC-51-A (Canada)	-	-
Threadlock 262 TA-26	WSK-M2G351-A6	-

GENERAL SPECIFICATIONS

Item	Specification
Reductant Tank Capacity
Inboard frame mounted reductant tank	Approximately 19.7L (5.2 gal)
Outboard frame mounted reductant tank	Approximately 21.7L (5.73 gal)

TORQUE SPECIFICATIONS

Description

lb-ft

lb-in

Bypass bolts ⁽¹⁾

Bypass outlet tube bolts

Charge Air Cooler (CAC) inlet tube clamp

Crankcase vent oil separator bolts and stud bolt

EGR cooler assembly bolts⁽¹⁾

EGR cooler end tank bolts and stud bolts⁽¹⁾

EGR valve inlet tube bolts⁽¹⁾

EGR valve inlet tube bracket bolts⁽¹⁾

EGR valve bolts⁽¹⁾

Exhaust Gas Recirculation Temperature (EGRT) sensor

Exhaust Pressure (EP) sensor tube nut

Fuel filter and bracket bolts and stud bolt

Fuel supply tube bolts

PCV fitting bolts

Reductant heater and sender assembly lock ring

Reductant injector nuts

Reductant pump assembly bolts

Reductant tank bolts

177

Reductant tank bracket bolts

177

Reductant tank strap bolts

Wiring harness bracket bolts

⁽¹⁾	Refer to the appropriate procedures in the service information.