LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Emission Control System -- F250-F550 Super Duty) >> Description And Operation >> Engine Emission Control - 6.2L (2V), 6.8L (3V) >> System Operation

System Operation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

As an engine runs, high-pressure gases are contained within the combustion chamber. Piston rings seal against the cylinder preventing the high pressure gases from passing into the crankcase between the side of the piston and the cylinder bore. Some amount of gas always leaks past the piston rings into the crankcase. If this blow-by gas could not escape then pressure would build up within the crankcase. Should the intake manifold's pressure be greater than the crankcase the PCV valve closes to prevent reversal of the exhausted air back into the crankcase again.

It is critical that the parts of the PCV system be kept clean and open, otherwise air flow will be insufficient. A plugged or malfunctioning PCV system eventually damages an engine. An engine's poorly maintained PCV system eventually becomes contaminated with sludge, causing serious engine problems.