LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Ignition System - 6.2L (2V) -- F250-F350 Super Duty) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  2. Remove the intake air resonator. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  3. Disconnect the 8 ignition wires.
  4. Disconnect the 8 ignition coil-on-plug electrical connectors.
  5. Remove the 8 ignition coil-on-plug bolts.
    • To install, tighten to 10 Nm (89 lb-in).
    6. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
  6. Remove the 8 ignition coil-on-plugs.
    7. NOTE: Verify that the ignition coil spring is correctly located inside the ignition coil-on-plug boot and that there is no damage to the tip of the boot.
  7. To install, reverse the removal procedure.
    • Apply a light coat of dielectric compound to the inside of the ignition coil boots.
scientia non olet · About LEMON Manuals