LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Fuel System - General Information -- F250-F550 Super Duty) >> General Procedures >> Quick Connect Coupling Retainer Clip >> Removal

Quick Connect Coupling Retainer Clip: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the top portion of the retainer clip by cutting both sides of the retainer clip below the tab of the primary latch.
    Fig 1: Removing Top Portion Of Retainer Clip By Cutting Both Sides Of Retainer Clip Below Tab Of Primary Latch
    G07484359Courtesy of FORD MOTOR CO.
  2. Grasp the side of the remaining retainer clip, pull outward and remove the retainer clip from the quick connect coupling body.
    Fig 2: Removing Retainer Clip From Quick Connect Coupling Body
    G07484360Courtesy of FORD MOTOR CO.
  3. Inspect the inside of the quick connector and remove any debris.
    Fig 3: Inspecting Inside Of Quick Connector
    G07484361Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals