Fuel System Pressure Release - Diesel Engine
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING:
Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this instruction may result in serious personal injury.
WARNING:
Do not work on the fuel system until the pressure has been released and the engine has cooled. Fuel in the high-pressure fuel system is hot and under very high pressure. High-pressure fuel may cause cuts and contact with hot fuel may cause burns. Failure to follow these instructions may result in serious personal injury.
- With the key in the OFF position make sure Fuel Conditioning Module pump is not running. Wait two minutes after pump has shut off for the low-pressure system to bleed off pressure.
- After the repair is complete, bleed the fuel system. For additional information, refer to FUEL SYSTEM BLEEDING - DIESEL ENGINE .
NOTE:
The fuel system cannot be relieved of pressure manually, the high-pressure fuel system loses pressure as the engine cools down. When working on the high-pressure fuel system wait until the engine is cool or 5 minutes, whichever is longer, to allow the high-pressure fuel system pressure to bleed off and the fuel to cool.