Brake Shift Interlock Actuator: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Install the park position switch.
1. Place the large plunger on the park position switch in the locating hole and position the switch as shown in illustration.
2. Rotate the park position switch counterclockwise making sure the tab locks under the housing lip.
  
  Fig 1: Rotating Park Position Switch Counterclockwise
  Courtesy of FORD MOTOR CO.
Verify small plunger is fully extended.

Fig 2: Locating Small Plunger
Courtesy of FORD MOTOR CO.
Install the BSIA.
1. Insert the BSIA into the selector lever mechanism housing.
2. Gently push the snap lock clip in place.
  
  Fig 3: Installing BSIA
  Courtesy of FORD MOTOR CO.
Install the BSIA screw.
- Tighten to 2 Nm (18 lb-in).
  
  Fig 4: Identifying BSIA Screw
  Courtesy of FORD MOTOR CO.
Install the selector lever mechanism. For additional information, refer to SELECTOR LEVER MECHANISM .