LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Automatic Transmission External Controls -- F250-F550 Super Duty) >> Diagnosis & Testing >> External Controls >> Inspection & Verification

Inspection & Verification

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern by operating the transmission external control.
  2. Visually inspect for obvious signs of mechanical and electrical damage; refer to the following chart:
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Damaged Brake Shift Interlock Actuator (BSIA)
    • Damaged Tow/Haul switch
    • Damaged Select Shift switch
    • Body Control Module (BCM) failed fuse(s):
      • 18 (10A)
      • 35 (5A)
    • PCM/Transmission Control Module (TCM)
    • Damaged wiring harness
    • Loose or damaged connections
    • Corroded or damaged terminals
  3. If the fault is not visually evident, determine the symptom. GO to Symptom Chart - External Controls  or GO to Symptom Chart - NVH .