LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Information System And Entertainment System -- F250-F550 Super Duty) >> Removal And Installation >> Rear Entertainment Module (RETM) >> Removal

Rear Entertainment Module (RETM): Removal

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Module configuration is required when a new Rear Entertainment Module (RETM) is being installed.
  1. Upload the RETM configuration to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
    2. NOTE: Open the RETM display.
  2. Remove the 4 screws.
  3. Remove the RETM.
    • Pull down on the sides of the RETM to disengage the clips from the bracket.
    • Using a suitable tool, push the rear most U-hook forward and release the U-hooks.
    • Hang the RETM on the J-hooks and disconnect the electrical connector.
    • Remove the RETM from the J-hooks.
scientia non olet · About LEMON Manuals