LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Wiper System & Washer System -- F250-F550 Super Duty) >> Removal And Installation >> Wiper Mounting Arm and Pivot Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cowl top vent panels. For additional information, refer to FRONT END BODY PANELS .
  2. Remove the 3 wiper mounting arm and pivot shaft bolts.
    • To install, tighten to 8 Nm (71 lb-in).
  3. Disconnect the wiper motor electrical connector.
  4. Remove the wiper mounting arm and pivot shaft assembly.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals