LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Steering Column -- F250-F550 Super Duty) >> Removal And Installation >> Steering Wheel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
  2. Turn the steering wheel to the straight-ahead position.
  3. Remove and discard the steering wheel bolt.
    • To install, tighten the new bolt to 48 Nm (35 lb-ft).
  4. Remove the steering wheel while routing the wires from the clockspring through the steering wheel.
  5. Tape the clockspring center rotor to the outer housing to keep it from rotating.
    Fig 1: Locating Outer Housing Center Rotor
    G06063996Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals