LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 746 (Parking Aid - Vehicles With: Parking Aid Camera) >> Diagnosis And Testing >> Parking Aid >> Symptom Chart(s) >> Rear Only Parking Aid Camera

Rear Only Parking Aid Camera

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .

Condition Possible Causes Actions
The rear parking aid camera is inoperative Refer to the Pinpoint Test If the vehicle is equipped with an 8 in (203 mm) touchscreen, PERFORM an APIM reset. REFER to: Reset the SYNC Module [APIM] .
If the concern is still present after the APIM reset, GO to Pinpoint Test A 
If the vehicle is equipped with a 4.2 in (107 mm) centerstack infotainment display, GO to Pinpoint Test A 
The FDIM or FCDIM displays REAR VIDEO CAMERA IS UNAVAILABLE or CAMERA IS UNAVAILABLE PLEASE CONTACT YOUR DEALERSHIP and a black screen/no image Refer to the Pinpoint Test If the vehicle is equipped with an 8 in (203 mm) touchscreen, PERFORM an APIM reset. REFER to: Reset the SYNC Module [APIM] .
If the concern is still present after the APIM reset, GO to Pinpoint Test A 
If the vehicle is equipped with a 4.2 in (107 mm) centerstack infotainment display, GO to Pinpoint Test A 
Static/flashing/blinking/flickering/scrolling or rolling image/screen/scrolling horizontal lines Refer to the Pinpoint Test GO to Pinpoint Test B 
Poor image quality (foggy/cloudy/fuzzy/blurry/hazy image or moisture/water in lens or black spots) Refer to the Pinpoint Test GO to Pinpoint Test B 
Camera image quality concern during an auto-start-stop event (vehicles with 2.7L engine only) Wiring, terminals or connectors
Direct Current/Direct Current (DC/DC) converter control module
REFER to: Direct Current/Direct Current (DC/DC) Converter Control Module .
Frozen screen or slow screen transitions (vehicles with an 8 in (203 mm) touchscreen) FDIM
APIM
PERFORM an APIM reset. REFER to: Reset the SYNC Module [APIM] . If the concern is still present after the APIM reset, DIAGNOSE the APIM and FDIM. Vehicles With: Touchscreen Display, REFER to: Information and Entertainment System . Vehicles With: Sony Audio System, REFER to: Information and Entertainment System .
Frozen screen or slow screen transitions (vehicles with a 4.2 in (107 mm) centerstack infotainment display) FCDIM DIAGNOSE the FCDIM. Vehicles Without: SYNC REFER to: Information and Entertainment System . Vehicles With: SYNC, REFER to: Information and Entertainment System .
Manual zoom function is inoperative Refer to the Pinpoint Test If the vehicle is equipped with an 8 in (203 mm) touchscreen, PERFORM an APIM reset. REFER to: Reset the SYNC Module [APIM] .
If the concern is still present after the APIM reset, GO to Pinpoint Test E 
If the vehicle is equipped with a 4.2 in (107 mm) centerstack infotainment display, GO to Pinpoint Test E 
Visual park aid alert is inoperative Refer to the Pinpoint Test If the vehicle is equipped with an 8 in (203 mm) touchscreen, PERFORM an APIM reset. REFER to: Reset the SYNC Module [APIM] .
If the concern is still present after the APIM reset, GO to Pinpoint Test C 
If the vehicle is equipped with a 4.2 in (107 mm) centerstack infotainment display, GO to Pinpoint Test C 
Active guidelines are inoperative or do no operate correctly Refer to the Pinpoint Test If the vehicle is equipped with an 8 in (203 mm) touchscreen, PERFORM an APIM reset. REFER to: Reset the SYNC Module [APIM] .
If the concern is still present after the APIM reset, GO to Pinpoint Test D 
If the vehicle is equipped with a 4.2 in (107 mm) centerstack infotainment display, GO to Pinpoint Test D 
Fixed guidelines are inoperative or do not operate correctly Refer to the Pinpoint Test If the vehicle is equipped with an 8 in (203 mm) touchscreen, PERFORM an APIM reset. REFER to: Reset the SYNC Module [APIM] .
If the concern is still present after the APIM reset, GO to Pinpoint Test D 
If the vehicle is equipped with a 4.2 in (107 mm) centerstack infotainment display, GO to Pinpoint Test D 
The video delay feature is inoperative or does not operate correctly Refer to the Pinpoint Test If the vehicle is equipped with an 8 in (203 mm) touchscreen, PERFORM an APIM reset. REFER to: Reset the SYNC Module [APIM] .
If the concern is still present after the APIM reset, GO to Pinpoint Test F 
If the vehicle is equipped with a 4.2 in (107 mm) centerstack infotainment display, GO to Pinpoint Test F 
Video image is upside down Internal parking aid camera failure
Incorrect parking aid camera installed on vehicle
INSTALL a new rear parking aid camera. REFER to: Rear Parking Aid Camera .
All other image concerns Refer to the Pinpoint Test GO to Pinpoint Test A