Pinpoint Test B : Poor Image Quality - Vehicles With Rear Only Parking Aid Camera: Notes

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Parking Aid for schematic and connector information.

Normal Operation and Fault Conditions

The video signal is transmitted from the camera to the APIM on shielded, twisted pair circuits. REFER to: Parking Aid - System Operation and Component Description .

Possible Causes

Dirty or scratched camera lens
Wiring, terminals or connectors
Fuse
Rear parking aid camera
APIM (vehicles with 8 in (203 mm) touchscreen)
Interference from other sources

Visual Inspection and Diagnostic Pre-Checks

If the vehicle is equipped with an 8 in (203 mm) touchscreen display, perform an APIM reset and reevaluate the concern prior to following this pinpoint test. REFER to: Reset the SYNC Module [APIM] .

NOTE: Before disconnecting the camera, verify the connector is properly seated and latched.