LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 741 (Front Seats System) >> Removal And Installation >> Front Center Seat Backrest - SuperCab/SuperCrew >> Removal

Front Center Seat Backrest - SuperCab/SuperCrew: Removal

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    Remove the front center seat. Refer to: Front Center Seat .

  1. 2.

    Position the seat cushion up.
GFD42946Courtesy of FORD MOTOR COMPANY

  1. 3.

    Remove the cup holder.
GFD42947Courtesy of FORD MOTOR COMPANY

  1. 4.

    Remove screws and the seat storage tray
GFD42948Courtesy of FORD MOTOR COMPANY

  1. 5.

    Position the seat cushion down.
GFD42949Courtesy of FORD MOTOR COMPANY

  1. 6.

    Release the seat latch and fold the seat backrest down.
GFD42950Courtesy of FORD MOTOR COMPANY

  1. 7.

    Remove the head restraint guide sleeves. Refer to: Front Head Restraint Guide Sleeve .

  1. 8.

    Remove the rear cup holder assembly.

    1. 1.

      Release the rear cup holder assembly retainers.

    1. 2.

      Disconnect the auxiliary power point electrical connector.
GFD42951Courtesy of FORD MOTOR COMPANY

  1. 9.

    If equipped, position the armrest storage compartment lid up.
GFD42952Courtesy of FORD MOTOR COMPANY

  1. 10.

    Remove the backrest latch cover.
GFD42953Courtesy of FORD MOTOR COMPANY

  1. 11.

    Remove the screws, release the retaining clip and remove the RH side shields.
GFD42954Courtesy of FORD MOTOR COMPANY

  1. 12.

    Remove the screws, release the retaining clips and remove the LH side shield.
GFD42955Courtesy of FORD MOTOR COMPANY

  1. 13.

    Release the seat latch and raise the seat backrest up.
GFD42956Courtesy of FORD MOTOR COMPANY

  1. 14.

    Remove the safety belt anchor bolt.

    Torque

    : 35 lb.ft (47 Nm)

GFD42957Courtesy of FORD MOTOR COMPANY

  1. 15.

    Remove the backrest.

    1. 1.

      Remove the stop bolt.

      Torque

      : 22 lb.ft (30 Nm)

    1. 2.

      Remove the pivot bolt.

      Torque

      : 33 lb.ft (45 Nm)

    1. 3.

      Remove the backrest latch upper bolts.

      Torque

      : 59 lb.ft (80 Nm)

GFD42958Courtesy of FORD MOTOR COMPANY