LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Auxiliary Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Trailer Brake Control (TBC) Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel upper center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
    2. NOTE: The clips holding the coin tray/storage bin or the auxiliary switch assembly (if equipped) to the center finish panel are very stiff. Care must be taken not to damage the coin tray/storage bin, switch assembly or center finish panel during removal.
    Fig 1: Locating Tabs And Coin Tray/Storage Bin
    G06762823Courtesy of FORD MOTOR CO.
  2. Press the 4 tabs and remove the coin tray/storage bin or the switch assembly (if equipped).
  3. Remove the Trailer Brake Control (TBC) module.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals