LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 738 (SEATBELT Systems) >> Removal And Installation >> Rear Seatbelt Buckle LH - Vehicles With: Inflatable Seatbelts >> Removal

Rear Seatbelt Buckle LH - Vehicles With: Inflatable Seatbelts: Removal

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    Depower the SRS. Refer to: Supplemental Restraint System (SRS) Depowering .

  1. 2.

    NOTE: The seat backrest latch is only accessible when the seat cushion is raised.
    NOTE: The striker should be in its lowest position for the latch to engage.

    Fold the LH rear seat backrest down.

    1. 1.

      Raise the seat cushion.

    1. 2.

      Release the seat latch.

    1. 3.

      Fold the seat backrest down.
GFD42767Courtesy of FORD MOTOR COMPANY

  1. 3.

    If equipped, remove the subwoofer.

    1. 1.

      Disconnect the electrical connector.

    1. 2.

      Remove the bolt.

      Torque

      : 62 lb.in (7 Nm)

    1. 3.

      Remove the nuts.

      Torque

      : 62 lb.in (7 Nm)

GFD43488Courtesy of FORD MOTOR COMPANY

  1. 4.

    Remove the nut and position the rear center safety belt anchor aside.

    Torque

    : 59 lb.ft (80 Nm)

GFD43489Courtesy of FORD MOTOR COMPANY

  1. 5.

    Disconnect the safety belt buckle electrical connector.
GFD43490Courtesy of FORD MOTOR COMPANY

  1. 6.

    Lift the rear seat backrest up.
GFD43491Courtesy of FORD MOTOR COMPANY

  1. 7.

    Lift the rear seat cushion up.
GFD43492Courtesy of FORD MOTOR COMPANY

  1. 8.

    Remove the safety belt buckle.
GFD43493Courtesy of FORD MOTOR COMPANY