DTC Chart(s): DTC
WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
| DTC | Description | Action |
|---|---|---|
| B11D6:11 | Driver Display Alert LED: Circuit Short To Ground | This DTC sets due to an incorrect or incomplete SODL or SODR configuration. Using a diagnostic scan tool, CARRY OUT PMI using as-built data. |
| B11D6:15 | Driver Display Alert LED: Circuit Short To Battery or Open | This DTC sets due to an incorrect or incomplete SODL or SODR configuration. Using a diagnostic scan tool, CARRY OUT PMI using as-built data. |
| U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to Pinpoint Test G |
| U0101:00 | Lost Communication with TCM: No Sub Type Information | |
| U0146:00 | Lost Communication with Gateway "A": No Sub Type Information | GO to Pinpoint Test H |
| U0199:00 | Lost Communication With "Door Control Module A": No Sub Type Information | GO to Pinpoint Test I |
| U0200:00 | Lost Communication With "Door Control Module B": No Sub Type Information | GO to Pinpoint Test J |
| U0401:86 | Invalid Data Received from ECM/PCM A: Signal Invalid | This continuous memory DTC sets when the SODL or SODR receives invalid network data from the PCM. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. If no PCM Diagnostic Trouble Codes (DTCs) exist, DIAGNOSE the observable symptom. |
| U0402:86 | Invalid Data Received from TCM: Signal Invalid | This continuous memory DTC sets when the SODL or SODR receives invalid transmission range network data from the PCM. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. If no PCM Diagnostic Trouble Codes (DTCs) exist, DIAGNOSE the observable symptom. |
| U049A:86 | Invalid Data Received From "Door Control Module A": Signal Invalid | This continuous memory DTC sets when the SODL receives invalid network data from the DDM. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. If no DDM Diagnostic Trouble Codes (DTCs) exist, DIAGNOSE the observable symptom. |
| U0501:86 | Invalid Data Received From "Door Control Module B": Signal Invalid | This continuous memory DTC sets when the SODR receives invalid network data from the PDM. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. If no PDM Diagnostic Trouble Codes (DTCs) exist, DIAGNOSE the observable symptom. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This continuous memory DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to this module. If there have been recent service actions with this module, INSTALL as-built data from Professional Technician Society (PTS) following diagnostic scan tool instructions under Module Programming>As-Built. REFER to: Module Configuration - System Operation and Component Description . If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. REFER to: Side Obstacle Detection Control Module . |
| U2300:55 | Central Configuration: Not Configured | This continuous memory DTC sets when the SODL or SODR does not detect the VIN information on the MS-CAN. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in all other modules. |
| U3000:44 | Control Module: Data Memory Failure | CLEAR the SODL or SODR Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the continuous memory or on-demand DTC U3000:44 returns, INSTALL a new SODL or SODR. REFER to: Side Obstacle Detection Control Module . |
| U3000:45 | Control Module: Program Memory Failure | CLEAR the SODL or SODR Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the continuous memory or on-demand DTC U3000:45 returns, INSTALL a new SODL or SODR. REFER to: Side Obstacle Detection Control Module . |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure | CLEAR the SODL or SODR Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the continuous memory or on-demand DTC U3000:46 returns, INSTALL a new SODL or SODR. REFER to: Side Obstacle Detection Control Module . |
| U3000:49 | Control Module: Internal Electronic Failure | CLEAR the SODL or SODR Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the continuous memory or on-demand DTC U3000:49 returns, INSTALL a new SODL or SODR. REFER to: Side Obstacle Detection Control Module . |
| U3002:62 | Vehicle Identification Number: Signal Compare Failure | This continuous memory DTC sets when the VIN stored in the SODL or SODR does not match the VIN that is broadcast on the network. CHECK the vehicle service history for recent service actions related to this module. If there have been recent service actions with this module, REPEAT the PMI procedure as directed by the diagnostic scan tool. REFER to: Module Configuration - System Operation and Component Description . If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. REFER to: Side Obstacle Detection Control Module . |
| DTC | Description | Action |
|---|---|---|
| B118C:11 | Left Blind Spot Warning Indicator: Circuit Short To Ground | GO to Pinpoint Test D |
| B118C:15 | Left Blind spot Warning Indicator: Circuit Short To Battery or Open | If the LH BLIS ®/Cross Traffic Alert (CTA) LED is inoperative, GO to Pinpoint Test D If the LH BLIS ®/Cross Traffic Alert (CTA) LED is always on, GO to Pinpoint Test C |
| All other DDM Diagnostic Trouble Codes (DTCs) | - | REFER to: Locks, Latches and Entry Systems . |
| DTC | Description | Action |
|---|---|---|
| B118D:11 | Right Blind Spot Warning Indicator: Circuit Short To Ground | GO to Pinpoint Test D |
| B118D:15 | Right Blind spot Warning Indicator: Circuit Short To Battery or Open | If the RH BLIS ®/Cross Traffic Alert (CTA) LED is inoperative, GO to Pinpoint Test D If the RH BLIS ®/Cross Traffic Alert (CTA) LED is always on, GO to Pinpoint Test C |
| All other PDM Diagnostic Trouble Codes (DTCs) | - | REFER to: Locks, Latches and Entry Systems . |