Bezel Diagnostics

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Check

1.

WARNING: Before beginning any service procedure in this article, refer to Health and Safety Precautions in GENERAL INFORMATION . Failure to follow this instruction may result in serious personal injury.

Refer to: Health and Safety Precautions .

NOTE: If there is a concern with one of the following components and Bezel Diagnostics cannot be accessed, obtain the module part number by referencing the label attached to the module.

Inoperative (blank or does not power on) FDIM
Inoperative FCIM
Inoperative steering wheel switch (for vehicles without a CD player)

Refer to appropriate article to diagnose the inoperative component.

2.

Ignition ON.

3.

Operate the audio system in AM/ FM mode.

* For vehicles with a CD player, press and hold the EJECT button, and within 1 second, press and hold the SEEK UP button. If supported, the Speaker Walk-Around Test will begin, and the display will indicate each speaker as it is tested.
* For vehicles without a CD player, simultaneously press and hold the steering wheel SEEK UP switch and FCIM TUNE UP button. If supported, the Speaker Walk-Around Test will begin, and the display will indicate each speaker as it is tested.

4.

Once the Speaker Walk-Around Test (All Speaker Test) is complete, the following information is available:

Menu	Submenu
APIM Diagnostics	Part Numbers
	Software Versions
	Configuration Status
	Location Information
	Tones Test
	Touchscreen Activation Test
	Display Test Pattern
	RGB Pixel Test
	IVSU Versions
	Exit Diagnostics
AHU Diagnostics (AHU refers to the ACM)	AHU Part Numbers (also displays SIRIUS ESN)
	Radio Signal Strength
	Speaker Walk-Around Test Active (if not equipped with audio DSP module)
	Exit Diagnostics
DSP Diagnostics (if equipped)	DSP Part Numbers
	Speaker Walk-Around Test Active
	Exit Diagnostics
EFP Diagnostics - if equipped (EFP refers to the FCIM that communicates on the CAN)	EFP Part Numbers
	Exit Diagnostics

5.

To exit the bezel diagnostics, press the FCIM on/off button or select "Exit Diagnostics."