LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Body Panel System - Front End Body Panels -- F250-F550 Super Duty) >> Removal And Installation >> Cowl Panel Grille >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the windshield wiper arms. For additional information, refer to WIPERS AND WASHERS .
  2. Remove the radio antenna mast.
  3. Remove the cowl panel weatherstrip.
    Fig 1: Locating Cowl Panel Weatherstrip
    G07485449Courtesy of FORD MOTOR CO.
  4. NOTE: Remove the cowl top vent panel from the center to avoid damage to the locating pins at each outer end of the cowl panels.
    Fig 2: Removing Cowl Top Vent Panel
    G07974707Courtesy of FORD MOTOR CO.
  5. Raise the cowl top vent panel.
  6. Remove the cowl top vent panel.
  7. To install, reverse the removal procedure.