LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Anti-Theft System - Passive Anti-Theft System -- F250-F550 Super Duty) >> General Procedures >> Passive Anti-Theft System (PATS) Parameter Reset

Passive Anti-Theft System (PATS) Parameter Reset

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOLS CHART

G06139341
 Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool
 
NOTE: This procedure applies to vehicles with and without Passive Anti-Theft System (PATS). For additional information, refer to PRINCIPLES OF OPERATION .
  1. Turn the key from the OFF position to the RUN position.
  2. From the scan tool, enter TOOLBOX. Select BODY - SECURITY - PATS Functions and follow the Integrated Diagnostic System (IDS) on-screen instructions to ENTER SECURITY ACCESS.
    3. NOTE: If the Body Control Module (BCM) was replaced on vehicles equipped with PATS, at least two keys must be programmed to the BCM. After completing step 3, do not disconnect the scan tool and follow the Erase All Keys and Program Two Keys procedure.
  3. From the scan tool, select "Parameter Reset" and follow the IDS on-screen instructions.
scientia non olet · About LEMON Manuals