Catalytic Converter RH: Installation

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

1.

NOTE: Loosely install the new RH catalytic converter nuts. Do not tighten at this time.

Position the RH catalytic converter in the vehicle. Loosely install the new RH catalytic converter nuts.

Courtesy of FORD MOTOR COMPANY

2.

Install the transmission support insulator. Refer to: Transmission Support Insulator .

3.

NOTE: Evenly tighten the RH catalytic converter nuts.

Tighten the RH catalytic converter nuts.

Torque

: 30 lb.ft (40 Nm)

Courtesy of FORD MOTOR COMPANY

4.

Connect the catalyst monitor sensor electrical connector.

Courtesy of FORD MOTOR COMPANY

5.

Connect the HO2S electrical connector.

Courtesy of FORD MOTOR COMPANY

6.

Install the LH catalytic converter. Refer to: Catalytic Converter LH .

7.

Install the muffler inlet pipe. Refer to: Muffler Inlet Pipe .

8.

Check the exhaust system for leaks.