LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 709 (Transmission Cooling System) >> Removal And Installation >> Transmission Fluid Warmer - 5.0L 32V Ti-VCT >> Installation

Transmission Fluid Warmer - 5.0L 32V Ti-VCT: Installation

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

  1. 1.

    Install the transmission fluid warmer and the bolts.

    Torque

    : 159 lb.in (18 Nm)

GFD41880Courtesy of FORD MOTOR COMPANY

  1. 2.

    Connect the coolant hoses, position the clamps and remove the hose clamping pliers. Remove the General Equipment:
GFD41879Courtesy of FORD MOTOR COMPANY

  1. 3.

    If installing a new transmission fluid warmer, install and lubricate a new cooler bypass valve O-ring seal.

    Material

    : Motorcraft® MERCON® LV Automatic Transmission Fluid / XT-10-QLVC (MERCON® LV) (WSS-M2C938-A)

GFD41809Courtesy of FORD MOTOR COMPANY

  1. 4.

    If installing a new transmission fluid warmer, install the cooler bypass valve and the bolts.

    Torque

    : 106 lb.in (12 Nm)

GFD41878Courtesy of FORD MOTOR COMPANY

  1. 5.

    Inspect and lubricate the band seals and backing rings. Install new band seals and backing rings if necessary.

    1. 1.

      Backing ring (7J324).

    1. 2.

      Seal (7D285).

      Material

      : Motorcraft® MERCON® LV Automatic Transmission Fluid / XT-10-QLVC (MERCON® LV) (WSS-M2C938-A)

GFD41842Courtesy of FORD MOTOR COMPANY

  1. 6.

    Connect the transmission fluid cooler tubes to the cooler bypass valve and the transmission fluid warmer and install the bolts.

    Torque

    : 89 lb.in (10 Nm)

GFD41877Courtesy of FORD MOTOR COMPANY

  1. 7.

    Inspect and lubricate the band seals and backing rings. Install new band seals and backing rings if necessary.

    1. 1.

      Backing ring (7J324).

    1. 2.

      Seal (7D285).

      Material

      : Motorcraft® MERCON® LV Automatic Transmission Fluid / XT-10-QLVC (MERCON® LV) (WSS-M2C938-A)

GFD41811Courtesy of FORD MOTOR COMPANY

  1. 8.

    Connect the transmission fluid cooler supply and return tubes to the cooler bypass valve and install the bolt.

    Torque

    : 18 lb.ft (25 Nm)

GFD41876Courtesy of FORD MOTOR COMPANY

  1. 9.

    Check and fill the transmission fluid as necessary. REFER to: Transmission Fluid Level Check .

  1. 10.

    Fill the degas bottle with the recommended coolant mixture and fill level.

    Material

    : Motorcraft® Orange Prediluted Antifreeze/Coolant / VC-3DIL-B (WSS-M97B44-D2)