DTC Charts
WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
BCM DTC Chart
NOTE:
Diagnose all PCM DTCs first.
| DTC | Description | Action |
|---|---|---|
| B11DB:02 | Battery Monitoring Module "A": General Signal Failure | GO to Pinpoint Test E |
| B11DB:08 | Battery Monitoring Module "A": Bus Signal / Message Failure | GO to Pinpoint Test E |
| B11DB:11 | Battery Monitoring Module "A": Circuit Short To Ground | GO to Pinpoint Test E |
| B11DB:49 | Battery Monitoring Module "A": Internal Electronic Failure | CLEAR the diagnostic trouble codes (DTCs). REPEAT the BCM self-test. If DTC B11DB:49 is retrieved, INSTALL new battery monitoring sensor. REFER to: Battery Monitoring Sensor . |
| B11DB:55 | Battery Monitoring Module "A": Not Configured | CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. INSTALL As-Built data from Professional Technician Society (PTS) following diagnostic scan tool instructions under Module Programming>As-Built. |
| B11DB:9A | Battery Monitoring Module "A": Component or System Operating Conditions | GO to Pinpoint Test E |
| B1489:11 | Battery Monitoring System (BMS) Sensor Power Circuit Short To Ground | GO to Pinpoint Test E |
| All Other DTCs | - | REFER to: Body Control Module (BCM) . |
PCM DTC Chart
| DTC | Description | Action |
|---|---|---|
| P0562 | System Voltage Low | GO to Pinpoint Test B |
| P0563 | System Voltage High | GO to Pinpoint Test A |
| P0620 | Generator Control Circuit | GO to Pinpoint Test G |
| P0625 | Generator Field/F Terminal Circuit Low | GO to Pinpoint Test H |
| P0626 | Generator Field/F Terminal Circuit High | GO to Pinpoint Test H |
| P065B | Generator Control Circuit Range/Performance | GO to Pinpoint Test G |
| P0A5A | Generator Current Sensor Circuit Range/Performance | GO to Pinpoint Test F |
| P0A5B | Generator Current Sensor Circuit Low | GO to Pinpoint Test F |
| P0A5C | Generator Current Sensor Circuit High | GO to Pinpoint Test F |
| P1397 | System Voltage Out Of Self-Test Range | If combined with P0562, GO to Pinpoint Test B If combined with P0563, GO to Pinpoint Test A |
| All Other DTCs | - | REFER to: ELECTRONIC ENGINE CONTROLS . |