Powertrain Control Module (PCM): Installation

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

1.

To install, reverse the removal procedure.

2.

NOTE: This step is only necessary when installing a new component.

Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. REFER to: Module Configuration - System Operation and Component Description .

3.

Carry out the Parameter Reset procedure. REFER to: Anti-Theft Security Access ANTI-THEFT SECURITY ACCESS .

4.

Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.