LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Controls - Powertrain DTC Charts & Descriptions (Diesel)) >> Diagnostic Trouble Code (DTC) Charts and Descriptions >> P0219 - Engine OVERSPEED Condition

P0219 - Engine OVERSPEED Condition

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
P0219 - ENGINE OVERSPEED CONDITION

Description:  Indicates the powertrain control module (PCM) has detected an engine overspeed condition. Under normal conditions engine overspeed is prevented by reducing the injected fuel mass but can happen if the engine is running by oil ingestion. To prevent short engine overspeeds from setting the DTC, the overspeed must last for a greater time period than a calibrated limit.
Possible Causes: 
  • Incorrect engine oil level
  • Incorrect RPM signal
  • Accelerator pedal to floor mat interference
  • Aftermarket performance products
  • Oil contaminated charge air cooler (CAC)
  • Incorrect downshift
  • Crankshaft position (CKP) sensor interference
  • Camshaft position (CMP) sensor interference
  • Excessive engine speed
Diagnostic Aids:  The DTC indicates the vehicle has been operated in a manner which caused the engine speed to exceed 4, 000 RPM for greater than 3 seconds.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.
scientia non olet · About LEMON Manuals