LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Engine Cooling - Diesel Engine -- F250-F550 Super Duty) >> Removal And Installation >> Cooling Fan Stator >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cooling fan. For additional information, refer to Cooling Fan .
  2. Detach the transmission fluid cooler-to-degas bottle hose retainer from the cooling fan stator.
  3. Remove the 4 cooling fan stator nuts and detach the cooling fan stator from the standoffs.
    • To install, tighten to 17 Nm (150 lb-in).
  4. Rotate the cooling fan stator as necessary to release the cooling fan stator from the lower cooling fan shroud and remove the cooling fan stator.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals