Turbocharger Oil Supply Tube RH: Removal

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Whenever turbocharger air intake system components are removed, always cover open ports to protect from debris. It is important that no foreign material enter the system. The turbocharger compressor vanes are susceptible to damage from even small particles. All components should be inspected and cleaned, if necessary, prior to installation or reassembly.

1.

With the vehicle in NEUTRAL, position it on a hoist. REFER to: Jacking and Lifting - Overview .

2.

Remove the engine appearance cover retainers and then remove the engine appearance cover.

Courtesy of FORD MOTOR COMPANY

3.

If equipped, remove the retainers and the transmission housing cover.

Courtesy of FORD MOTOR COMPANY

4.

NOTE: Vehicles come with a skid plate or a splash shield.

NOTE: Skid plate shown in illustration, splash shield similar.

If equipped, remove the bolts and the skid plate or splash shield.

Courtesy of FORD MOTOR COMPANY

5.

Remove the RHF fender splash shield. REFER to: Fender Splash Shield .

6.

Remove the Air Cleaner Outlet Pipe RH. REFER to: AIR CLEANER OUTLET PIPE RH .

7.

Remove the RHCAC intake pipe. REFER to: CHARGE AIR COOLER (CAC) INTAKE PIPE .

8.

Remove the Accessory Drive Belt. REFER to: ACCESSORY DRIVE BELT .

9.

Remove the A/C compressor mounting bolts and position the A/C compressor aside.

Courtesy of FORD MOTOR COMPANY

10.

Remove the TC oil supply tube bolts and then remove the TC oil supply tube.

Courtesy of FORD MOTOR COMPANY

11.

Remove and discard the TC oil supply tube O-ring seals and the TC oil supply tube oil filter.

Courtesy of FORD MOTOR COMPANY