Cooling Module: Installation
WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- 2.NOTE: Only use the specified material to lubricate the seals.
Install new condenser fitting O-ring seals.
Material
: Motorcraft® PAG Refrigerant Compressor Oil / YN-12-D (WSH-M1C231-B)
- 3.
Fill and bleed the cooling system. REFER to: Cooling System Draining and Vacuum Filling .
- 4.
Check and fill the transmission fluid. REFER to: Transmission Fluid Level Check .