Valve Cover RH: Installation
WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- 1.NOTE: Installation of new seals is only required if damaged seals were removed.
Using the special tools, install new spark plug tube seals.
Use Special Service Tool: 205-153 (T80T-4000-W) Handle, 303-1247 VCT Spark Plug Tube Seal Remover and Installer.
- 2.NOTE: Installation of new seals is only required if damaged seals were removed.
Using the special tools, install new VCT variable force solenoid seals.
Use Special Service Tool: 205-153 (T80T-4000-W) Handle, 205-142 (T80T-4000-J) installer, Differential Bearing Cone.
- 4.NOTE: If the valve cover is not installed and the fasteners tightened within 5 minutes, the sealant must be removed and the sealing area cleaned.
Apply an 8 mm (0.31 in) bead of silicone gasket and sealant to the engine front cover-to-cylinder head joints.
Material
: Silicone Gasket and Sealant / TA-30 (WSE-M4G323-A4)
- 6.NOTE: 4x2 shown in illustration, 4x4 similar.
- Attach the wiring harness retainers.
- Connect the VCT variable force solenoid electrical connectors.
- 8.
Install the RH ignition coils. Refer to: IGNITION COIL-ON-PLUG .
- 11.
Position the PCV tube and connect the quick release couplings. Refer to: QUICK RELEASE COUPLING .
- 12.
Fill the engine cooling system. Refer to: COOLING SYSTEM DRAINING AND VACUUM FILLING .