Timing Chain: Removal
WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The timing chain alignment procedure has changed from prior model year engines and must be followed exactly or damage to the engine will result.
NOTE:
During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
NOTE:
In order to remove the LH timing chain, the RH timing chain must be removed first.
RH and LH timing chains
- 1.
Remove the engine front cover. Refer to: Engine Front Cover .
- 2.
Using the special tool, rotate the crankshaft clockwise until the keyway is at the 7:30 position.Use Special Service Tool: 303-448 (T93P-6303-A) Holding Tool, Crankshaft.
- 3.
Verify the timing mark on the RHVCT unit is on top, if not, rotate the crankshaft clockwise one complete revolution so the keyway is at the 7:30 position.
- 5.NOTE: It may be necessary to rotate the crankshaft slightly to provide enough slack in the chain to remove the RH timing chain tensioner arm. Return the crankshaft keyway to the 7:30 position after removing the RH timing chain tensioner arm.
Remove the RH timing chain tensioner arm.
- 6.NOTE: It may be necessary to rotate the crankshaft slightly to provide enough slack in the chain to remove the RH timing chain guide. Return the crankshaft keyway to the 7:30 position after removing the RH timing chain guide.
Remove the bolt and the RH timing chain guide.
LH timing chain
- 8.
Using the special tool, rotate the crankshaft clockwise one complete revolution.Use Special Service Tool: 303-448 (T93P-6303-A) Holding Tool, Crankshaft.
- 9.
Using the special tool, rotate the crankshaft clockwise until the keyway is at the 3:30 position.Use Special Service Tool: 303-448 (T93P-6303-A) Holding Tool, Crankshaft.
- 11.NOTE: It may be necessary to rotate the crankshaft slightly to provide enough slack in the chain to remove the LH timing chain tensioner arm. Return the crankshaft keyway to the 3:30 position after removing the LH timing chain tensioner arm.
Remove the LH timing chain tensioner arm.
- 12.NOTE: It may be necessary to rotate the crankshaft slightly to provide enough slack in the chain to remove the LH timing chain guide. Return the crankshaft keyway to the 3:30 position after removing the LH timing chain guide.
Remove the bolt and the LH timing chain guide.