LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 668 (Passive Anti-Theft System (Pats)) >> Diagnosis And Testing >> Passive Anti-Theft System (PATS) >> DTC Charts

DTC Charts

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .

BCM DTC Chart 

DTC Description Action
B10D5:13 PATS Antenna: Circuit Open INSTALL a new PATS transceiver. REFER to: Passive Anti-Theft System (PATS) Transceiver .
B10D7:05 PATS Key: System Programming Failure GO to Pinpoint Test B 
B10D7:51 PATS Key: Not Programmed PROGRAM the PATS key in question. REFER to: ANTI-THEFT SECURITY ACCESS .
B10D7:55 PATS Key: Not Configured The CEI Lock Configuration within the BODY>SERVICE FUNCTIONS tab was not completed during the PMI procedure. CARRY OUT the CEI Lock Configuration as part of the PMI procedure.
B10D7:87 PATS Key: Missing Message GO to Pinpoint Test D 
B10D7:8F PATS Key: Erratic GO to Pinpoint Test C 
B10D8:00 PATS Key Less Than Minimum Programmed: No Sub Type Information Less than 2 keys are programmed (minimum of 2 keys must be programmed). CYCLE the customer's second key in the ignition key cylinder to program (when less than 2 keys are programmed, the BCM automatically programs the first 2 keys that are cycled in the ignition key cylinder).
B10D9:87 PATS Transponder: Missing Message GO to Pinpoint Test E 
B10DA:51 PATS Target Identifier: Not Programmed There is no PCM ID stored in the BCM memory. CARRY OUT the parameter reset procedure. REFER to: ANTI-THEFT SECURITY ACCESS .
C113A:11 Wakeup Control: Circuit Short To Ground GO to Pinpoint Test F 
C113A:15 Wakeup Control: Circuit Short To Battery or Open GO to Pinpoint Test F 
All other Diagnostic Trouble Codes (DTCs) - REFER to: Body Control Module (BCM) .

Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .

PCM DTC Chart 

DTC Description Action
P161A Incorrect Response from Immobilizer Control Module The BCM ID received by the PCM does not match the ID stored in the PCM memory. CARRY OUT the parameter reset procedure. REFER to: ANTI-THEFT SECURITY ACCESS .
All other Diagnostic Trouble Codes (DTCs) - REFER to the PCM DTC Chart in the appropriate Electronic Engine Controls article.