LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Instrument Panel And Console -- F250-F550 Super Duty) >> Removal And Installation >> Instrument Cluster Finish Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the steering column in the downward and rearward position.
  2. Remove the upper instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL FINISH PANEL - CENTER, UPPER .
  3. Remove the steering column opening trim panel.
  4. Remove the 4 instrument cluster finish panel screws.
    • Remove the tree type retainers for the gap hider.
  5. Remove the instrument cluster finish panel.
    • If equipped, disconnect the electrical connectors.
  6. To install, reverse the removal procedure.
    • Make sure to align the trim panel retaining clips to the adjacent retaining clip holes.
scientia non olet · About LEMON Manuals