LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Instrument Panel And Console -- F250-F550 Super Duty) >> Removal And Installation >> Console - Overhead >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull the rear edge of the overhead console downward, at the locations shown in illustration, and then pull rearward.
    Fig 1: Identifying Overhead Console Rear Edge Pulling Locations
    G06462852Courtesy of FORD MOTOR CO.
  2. Disconnect the electrical connectors.
  3. Remove the overhead console.
  4. To install, reverse the removal procedure.
    • Make sure to align the overhead console retaining clips to the adjacent clip holes.
scientia non olet · About LEMON Manuals