Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear door push button rod. For additional information, refer to PUSH BUTTON ROD - REAR, CREW CAB .
Remove the rear door push button rod linkage. For additional information, refer to PUSH BUTTON ROD - LINKAGE, HORIZONTAL, REAR DOOR, CREW CAB .

NOTE: When drilling out the push button rod bellcrank rivet, do not oversize the hole in the door sheet metal.

NOTE: Use the special tool to install the new rivets.

Remove the push button rod bellcrank.
1. Remove the rivet mandrel (center).
2. Drill out the rivet.
3. Remove the push button rod bellcrank.
  
  Fig 1: Locating Rivet Mandrel (Center), Rivet And Push Button Rod Bellcrank
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Using the Heavy Duty Riveter, install the new rivets.