LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Handles, Locks, Latches And Entry Systems -- F250-F550 Super Duty) >> Removal And Installation >> Keyless Entry Keypad >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the water shield aside.
  3. Disconnect the keyless entry keypad electrical connector.
  4. Remove the retaining clip and the keyless entry keypad and harness.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals