LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Handles, Locks, Latches And Entry Systems -- F250-F550 Super Duty) >> Removal And Installation >> Ignition Lock Cylinder - Non Functional >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. For additional information, refer to STEERING COLUMN .
  2. Remove the ignition lock cylinder.
    • Use an 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
    • Use a 3/8-inch diameter drill bit to drill down the middle of the ignition lock cylinder key slot until the ignition lock cylinder breaks loose.
    • Remove and discard the ignition lock cylinder from the steering column.
  3. Thoroughly clean all drill shavings from the steering column and inspect it for damage.
scientia non olet · About LEMON Manuals