LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Handles, Locks, Latches And Entry Systems -- F250-F550 Super Duty) >> Removal And Installation >> Ignition Lock Cylinder - Functional >> Removal

Ignition Lock Cylinder - Functional: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Passive Anti-Theft System (PATS) transceiver. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
  2. Remove the ignition lock cylinder in the following sequence:
    1. Insert the ignition key and position the ignition lock cylinder to the ACC position.
    2. Using a suitable tool, depress the ignition lock cylinder release pin through the access hole while pulling the ignition lock cylinder outward.
      Fig 1: Locating Ignition Lock Cylinder Release Pin
      G06173861Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals