LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 610 (Wiper System & Washer System) >> Removal And Installation >> Wiper Mounting Arm and Pivot Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
  2. Remove the 3 wiper mounting arm and pivot shaft bolts.
    • To tighten, tighten to 8 Nm (71 lb-in).
  3. Disconnect the wiper motor electrical connector.
  4. Remove the wiper mounting and pivot shaft assembly.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals