Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If both latches need to be removed, repeat steps for other side.
- Remove the seat cushion. For additional information, refer to SEAT - REAR, SUPERCAB .
- Remove the support-to-latch bolts.
- Remove the upper support-to-latch bolt.
- To install, tighten to 33 Nm (24 lb-ft).
- Remove the lower support-to-latch bolt.
- To install, tighten to 25 Nm (18 lb-ft).
- Remove the upper support-to-latch bolt.
- Remove the latch cover.
- Remove the latch-to-cushion frame bolt and latch.
- To install, tighten to 33 Nm (24 lb-ft).
- To install, reverse the removal procedure.