Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Prior to installing a new Dual Climate Controlled Seat Module (DCSM), upload the module configuration information to the appropriate scan tool. This information must be downloaded into the new DCSM after installation. For additional information, refer to MODULE CONFIGURATION .

NOTE: For component identification and locations, refer to SEAT CUSHION - FRONT, BUCKET SEAT .

When installing a new DCSM, carry out the appropriate steps in Programmable Module Installation (PMI). For additional information, refer to MODULE CONFIGURATION .
From under the front of the front passenger seat, remove the DCSM in the following sequence.
1. Remove the 2 DCSM screws.
2. Release the locking wedges on the 2 DCSM electrical connectors.
3. Disconnect the electrical connectors.
4. Remove the DCSM.
  
  Fig 1: Removing DCSM
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
If a new DCSM has been installed, carry out the appropriate steps in PMI. For additional information, refer to MODULE CONFIGURATION .