Driver Seat Module (DSM): Removal

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Typical head restraint guide sleeve shown in illustration, others similar.

Push in on the head restraint guide sleeve release button(s) and remove the head restraint.
Obtain a flat-head screwdriver with a width of 4 mm (0.157 in) to 7 mm (0.275 in) and a thickness of approximately 1 mm (0.039 in).
Align the screwdriver to the middle of the head restraint guide sleeve release button.

Fig 1: Aligning Screwdriver To Middle Of Head Restraint Guide Sleeve Release Button
Courtesy of FORD MOTOR CO.
Position the screwdriver between the head restraint guide sleeve neck and backrest trim cover and foam pad.

Fig 2: Locating Screwdriver Positon Between Head Restraint Guide Sleeve Neck And Backrest Trim Cover And Foam Pad
Courtesy of FORD MOTOR CO.
Position the screwdriver at a 45-degree angle.

Fig 3: Identifying Screwdriver Position
Courtesy of FORD MOTOR CO.

NOTE: For retainer clarity, backrest trim cover and foam pad are removed.

NOTE: Typical retaining feature shown in illustration.

Fig 4: Locating Bending Lock Feature On Head Restraint Guide Sleeve In

Courtesy of FORD MOTOR CO.

Push the screwdriver in, bending the lock feature on the head restraint guide sleeve in.
While bending the lock feature in, push down on the screwdriver handle, prying the head restraint guide sleeve up and disengaging it from the backrest frame crossmember.

Fig 5: Disengaging Head Restraint Guide Sleeve From Backrest Frame Crossmember
Courtesy of FORD MOTOR CO.
Remove the head restraint guide sleeve.
- Discard the head restraint guide sleeve.
Repeat these steps for the head restraint guide sleeve on the opposite side.