Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Prior to installation of a new Driver Seat Module (DSM), upload the module configuration information to the appropriate scan tool. This information must be downloaded into the new DSM after installation. For additional information, refer to
MODULE CONFIGURATION
.
NOTE:
For component identification and locations, refer to SEAT CUSHION - FRONT, BUCKET SEAT .
- When installing a new DSM, carry out the appropriate steps in Programmable Module Installation (PMI). For additional information, refer to MODULE CONFIGURATION .
- From under the front of the driver seat, remove the 2 DSM screws, disconnect the electrical connectors and remove the DSM.
- To install, reverse the removal procedure.
- If a new DSM has been installed, carry out the appropriate steps in PMI. For additional information, refer to MODULE CONFIGURATION .