LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 609 (Handles, Locks, Latches And Entry Systems) >> Diagnosis And Testing >> Handles, Locks, Latches and Entry Systems >> Pinpoint Tests >> Pinpoint Test I: An Individual Button/Feature Is Inoperative From The Remote Keyless Entry (RKE) Transmitter >> Pinpoint Test I: An Individual Button/Feature Is Inoperative From The RKE Transmitter

Pinpoint Test I: An Individual Button/Feature Is Inoperative From The RKE Transmitter

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. I1 VERIFY THE DOOR LOCK OPERATION 
    • Press the lock and unlock button from the driver door lock control switch while observing the door lock operation.

    Do the door locks operate correctly? 

  2. I2 VERIFY THE HORN OPERATION 
    • Enter the following diagnostic mode on the scan tool: BCM  Data Logger.
    • Select the BCM  PID (HORN) and active command the horn on.

    Does the horn sound when commanded on? 

    • Yes  : GO to I3  .
    • No  : REFER to HORN .
  3. I3 VERIFY THE HAZARD LAMP OPERATION 
    • Place the hazard switch in the ON position.

    Do the hazard lamps operate correctly? 

    • Yes  : For vehicles without remote start, REPLACE the inoperative IKT  and PROGRAM the new IKT  individually or PROGRAM all the IKTs  . REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) for the programming procedures. If all the IKTs  are to be programmed, INFORM the customer that any IKTs  not present need to be programmed. TEST the system for normal operation.

      For vehicles equipped with the factory remote start, GO to I4  .

    • No  : REFER to EXTERIOR LIGHTING .
  4. I4 VERIFY THE REMOTE START BUTTON 
    • Enter the following diagnostic mode on the scan tool: BCM  Data Logger.
    • Select the BCM  PID (LST_RKE_xMTR) while pressing the remote start button on an IKT  .

    Does the PID indicate the remote start button is being pressed? 

    • Yes  : REFER to STARTING SYSTEM .
    • No  : REPLACE the inoperative IKT  and PROGRAM the new IKT  individually or PROGRAM all the IKTs  . REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) for the programming procedures. If all the IKTs  are to be programmed, INFORM the customer that any IKTs  not present need to be programmed.

      TEST the system for normal operation.

scientia non olet · About LEMON Manuals