Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For parts identification and location, refer to SEAT - EXPLODED VIEW, FRONT .

Remove the seat cushion cover. For additional information, refer to SEAT CUSHION COVER - FRONT .
Remove the screw from the Thermo-Electric Device (TED) mounting bracket.
Remove the cushion TED .
- Disconnect the electrical connector.
- Detach the pin-type retainer and wiring harness.
- Route the wiring harness and remove the TED .
To remove the TED mounting bracket, un-hook from the cushion support wires.
To install, reverse the removal procedure.