Removal and Installation
WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For parts identification and location, refer to SEAT - EXPLODED VIEW, FRONT .
- Position the seat backrest fully forward.
- Release the backrest cover J-clip and unzip the 2 zippers.
- Disconnect the Thermo-Electric Device (TED) electrical connector.
- Detach the pin-type retainer attaching the TED duct to the backrest frame.
- Un-hook the TED
from the backrest support wire and remove.
- If equipped with power lumbar, note cable routing for correct installation.
- To install, reverse the removal procedure.