Seat Cushion - Rear, CrewCab: Disassembly
WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For parts identification and location, refer to SEAT - EXPLODED VIEW, REAR, CREW CAB .
- Remove the sea t cushion latch. Refer to SEAT LATCH - REAR, CREW CAB .
- Remove the cushion foam pad.
- If equipped, disconnect the cushion heater mat electrical connector.
- Note the wire harness routing for correct installation.
- If equipped, disconnect the cushion heater mat electrical connector.
- Remove the bolt and safety belt buckle.
- To install, tighten to 32 Nm (24 lb-ft).
- Remove the screw and inboard side shield.
- Remove the inboard pivot bolt, inboard pedestal and cushion.
- To install, tighten to 32 Nm (24 lb-ft).
- To assemble, reverse the disassembly procedure.