Pinpoint Test Ag: DTC B19A4
- AG1 CHECK THE BACKREST TED BLOWER SPEED CONTROL CIRCUIT FOR A SHORT TO VOLTAGE
- Ignition OFF.
- Depower the SRS . Refer to SUPPLEMENTAL RESTRAINT SYSTEM .
- Disconnect: Driver Seat Side Air Bag Module C3051 .
- Disconnect: Passenger Seat Side Air Bag Module C339 .
- Disconnect: DCSM C3265C .
-
WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any airbag when the battery is connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
Connect the battery ground cable. Refer to BATTERY, MOUNTING AND CABLES .
- Ignition ON.
- Measure the voltage between C3265C-12 , circuit CHS09 (GY), harness side and ground.
Is any voltage present?
- Yes : GO to AG2 .
- No : GO to AG3.
- AG2 CHECK THE BACKREST TED BLOWER SPEED CONTROL CIRCUIT FOR A SHORT TO VOLTAGE
- Disconnect: Backrest TED C3034 .
- Measure the voltage between C3265C-12 , circuit CHS09 (GY), harness side and ground.
Is any voltage present?
- Yes
: REPAIR the circuit. CLEAR the DTCs. REPEAT the self-test.
DISCONNECT the battery ground cable.
CONNECT driver seat side air bag module C3051 and passenger seat side air bag module C339 .
REPOWER the SRS . REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
- No : GO to AG3 .
- AG3 CHECK THE BACKREST TED BLOWER SPEED CONTROL AND BLOWER OUTPUT CIRCUITS FOR A SHORT TOGETHER
- Ignition OFF.
- Disconnect: Backrest TED C3034 .
- Measure the resistance between DCSM C3265C-12 , circuit CHS09 (GY), harness side and C3265C-16 , circuit CHS03 (GN/BN), harness side.
Is the resistance greater than 10, 000 ohms?
- Yes : GO to AG4 .
- No
: REPAIR the circuits. CLEAR the DTCs. REPEAT the self-test.
DISCONNECT the battery ground cable.
CONNECT driver seat side air bag module C3051 and passenger seat side air bag module C339 .
REPOWER the SRS . REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
- AG4 CHECK THE BACKREST TED RESISTANCE FOR AN INTERNAL SHORT
- Measure the resistance between backrest TED C3034 pins 2 and 7, component side.
Is the resistance greater than 10, 000 ohms?
- Yes
: INSTALL a new DCSM
. REFER to DUAL CLIMATE CONTROLLED SEAT MODULE (DCSM) . CLEAR the DTCs. REPEAT the self-test.
DISCONNECT the battery ground cable.
CONNECT driver seat side air bag module C3051 and passenger seat side air bag module C339 .
REPOWER the SRS . REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
- No
: INSTALL a new backrest TED
. REFER to SEAT BACKREST THERMO-ELECTRIC DEVICE . CLEAR the DTCs. REPEAT the self-test.
CONNECT driver seat side air bag module C3051 and passenger seat side air bag module C339 .
REPOWER the SRS . REFER to SUPPLEMENTAL RESTRAINT SYSTEM .