Removal and Installation
WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear seat backrest. For additional information, refer to additional information, refer to SEATING .
- Pull upward to release the scuff plate clips and remove the scuff plate trim panel.
- Detach the scuff plate from the weatherstrip.
- Reposition the rear door weatherstrip.
- Remove the B-pillar trim panel pin-type retainer.
- Remove the B-pillar trim panel bolt cover.
-
NOTE: Starting at the top of the cover, use a non-marring tool.
Remove the B-pillar trim panel bolt.
- To install, tighten to 9 Nm (80 lb-in).
- Pull inward to release the B-pillar trim panel clips.
- Reposition the B-pillar trim panel.
- Remove the safety belt anchor bolt.
- To install, tighten to 40 Nm (30 lb-ft).
- Reposition the safety belt through the B-pillar trim panel and remove the B-pillar trim panel.
- To install, reverse the removal procedure.